![]() ![]() Checked to make sure CoolTerm was connected with CTS checked.Now you are ready to send a gcode file.If CTS is enabled, you should see something like this: You just issued getter command in TinyG for the CTS enabled property. Once you are able to type into the input box issue a CTS query by sending: To check this you will need to click in the text input box in CoolTerm. It IS enabled by default, but it is always good to make sure before sending files that will depend on CTS. However, we need to make sure CTS is enabled on TinyG. Technically, we could send a file to TinyG now.As long as you have the right port selected and the right baud rate set, you should now be connected to TinyG. Once you are done checking CTS go ahead and click OK.Please make sure CoolTerm has CTS checked!** Now that you have clicked the options button you should see something like this: We need to change one value in the Options of Coolterm BEFORE we connect to TinyG. If you are now connected to TinyG with CoolTerm, disconnect.See Connecting to TinyG for complete instructions on how connected to TinyG with CoolTerm. Make sure you have CoolTerm installed and you are able to connect to TinyG.If you cancel a job in progress, unsent code in the send buffer could crash your machine. ![]() ![]() Asynchronous Commands are not available during a file send. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |